stereo delay reverb pedal Keeley Nocturne Andy Timmons Reverb Pedal

stereo delay reverb pedal Keeley Nocturne Andy Timmons Reverb PedalThe Andy Timmons signature stereo reverb pedal! From Keeley Tone Controls the tone of the reverb. CCW for darker reverb trail, CW for brighter reverb trail Level Controls the output level of the reverb Decay Controls the length of the reverb trail. CCW for less decay, CW for more decay. Modulation Controls the amount of modulation in the reverb trail. Mode Switch This switch toggles between reverb modes: Nocturne, Spring, Plate Left Switch This switch

The Andy Timmons signature stereo reverb pedal! 

From Keeley -

Tone – Controls the tone of the reverb. CCW for darker reverb trail, CW for brighter reverb trail
Level – Controls the output level of the reverb
Decay – Controls the length of the reverb trail. CCW for less decay, CW for more decay.
Modulation – Controls the amount of modulation in the reverb trail.
Mode Switch – This switch toggles between reverb modes: Nocturne, Spring, Plate
Left Switch – This switch turns the effect on and off.
Right Switch – This switch turns the preset on and off. When the preset is active the LED will change from BLUE to RED. Changing any parameter from the preset value will cause the LED to blink. The LED will stop blinking when the parameter is changed back to its preset value. To save the current settings, press and hold the Right Switch until the bypass LED blinks.

Secondary Functions

• High Pass Filter – Press and hold the Mode Switch while adjusting the Tone to change the low end response of the reverb.
• Pre-delay Time – Press and hold the Mode Switch while adjusting the Decay to change the pre-delay length. 0 to 250ms.
• True Bypass/Buffered Bypass – Press and hold the Left Switch until the bypass LED blinks to switch between Buffered-Bypass (LED blinks three times) or True-Bypass (LED blinks twice). The default is Buffered-Bypass.
• Save Preset – With the effect on and the preset active, press and hold the Right Switch until the bypass LED blinks to save all of the current parameters.
• EXP/MIDI Reverb Mode Switch – Toggle through the reverb modes using a momentary switch with a mono TS cable connected to the EXP/MIDI jack. (The EXP/MIDI jack has to be set to Expression mode). The reverb modes can also be toggled by pressing both Left and Right Switches at the same time.

Power Up Functions

Factory Reset – Press and hold the Left and Right foot-switches and the Mode Switch while applying power to the unit. The mode and bypass LEDs will blink several times to indicate the reset was successful.
Wet+Dry/Wet Only – Press and hold the Left foot-switch and Mode Switch while applying power to the unit. The bypass LED will blink BLUE twice for wet+dry and three times for wet only. The default is wet+dry.
Left Wet/Right Dry – The unit can be set up to where the left output is just the wet signal while the right output is just the dry signal. Press and hold the Right foot-switch while applying power to the unit to activate or disable this feature. The bypass LED will blink BLUE two times for off and three times for on. The default is off.
Trails – Press and hold the Left and Right foot-switches while applying power to the unit. The bypass LED will blink BLUE twice if trails is on and three times if trails is off. The default is with trails on.
Momentary/Latching Remote Switching – Press and hold the Left foot-switch while applying power to the unit. The bypass LED will blink BLUE twice for momentary and three times for latching. The default is momentary.